Servo Siemens V90 MOTOR

SIMOTICS S-1FL6 servomotors are naturally cooled, permanent-magnet synchronous motors where the heat is dissipated through the motor surface. The motors can be simply and quickly installed using the full thread and quick-release connectors. They have a 300 percent overload capability and can be combined with SINAMICS V90 converter to create a powerful servo system with a high degree of functionally.

SIMOTICS S-1FL6 servomotor – SINAMICS V90 system

SIMOTICS S-1FL6, Low Inertia (LI) for high dynamic Performance

SIMOTICS S-1FL6, LI, Shaft heights 20, 30, 40, 50 mm

Technical data

Shaft heights:

20 mm, 30 mm, 40 mm, 50 mm

Rated torque:

0.16 Nm up to 6.37 Nm

Rated/max. speed:

3000 rpm / 5000 rpm

Encoder:

Incremental encoder TTL 2500 ppr;
Absolute encoder single-turn 21-bit

Degree of protection:

IP65

Option:

Holding brake

Shaft type:

Plain shaft or feather key

SIMOTICS S-1FL6, High Inertia (HI) for smooth operation performance

SIMOTICS S-1FL6, HI, Shaft heights 95, 65, 45 mm

Technical data

Shaft heights:

45 mm, 65 mm, 95 mm

Rated torque:

1.27 Nm up to 33.40 Nm

Rated/max. speed:

2000 rpm / 3000 rpm

Encoder:

Incremental encoder TTL 2500 ppr;
Absolute encoder 20-bit + 12-bit multi-turn

Degree of protection:

IP65

Option:

Holding brake

Shaft type:

Plain shaft or feather key
 

Servo SIEMENS V90 CABLE

Select your MOTION-CONNECT 300 connection system

• Power cable acc. to length and cross section (orange)

• Encoder cable acc. to length and encoder type (green)

• Brake cable if motor holding brake is selected acc. to length (black)

• Control/setpoint cable to connect the drive to the PLC (grey)

• Connectors can also be ordered separately

Cables and connectors – SINAMICS V90 system

 

Power cable

Encoder cable

Brake cable

  Setpoint cable
 

Length

3 m

3 m

5 m

Control/setpoint cable, 1 m cable, with a connector (MDR 50-pin connector, free pins to controller side) 
or 
Control/setpoint cable 0.5 m cable, with connectors on both sides and a separate terminal block (MDR 50-pin connector, terminal block to controller side)
or
Control/setpoint cable, 1 m cable, with a connector (MDR 20-pin connector, free pins to controller side)

Length

5 m

5 m

5 m

Length

7 m*

7 m*

7 m*

Length

10 m

10 m

10 m

Length

20 m

20 m

20 m

Option

  

For  incremental Encoder

  

Option

  

For absolute Encoder

  

 * 7 m cable length is only available for high inertia motors (3 AC 400V)

PROFINET Cable

  

IE FC RJ45 Plug with IE FC TP Trailing Cable

IE FC TP Standard Cable 2x2

IE CONNECTING CABLE IE FC RJ45 PLUG-180

Connectors

     

Encoder connector

50-pin MDR connector for setpoint cable

Power connector

Brake connector

Incremental 13-bit encoder connector

Absolute 20-bit encoder connector (only for high intertia 3AC 400V)

Converter side

Converter side

Motor side

Motor side

Motor side

Motor side